Carbon plus a dedicated fluoride stage, sized for one or two people.
Best for: 1-2 people who want fluoride reduced too, in an apartment, office, RV or boat galley.
Why You'll Care
- Two stages: coconut-shell carbon first, then stainless steel Post-Treat filters made specifically for fluoride.
- Independent lab tests: lead and PFAS (PFOA/PFOS) reduced below detection limits, and fluoride cut 90%. Full results are on this page.
- 1.6 gallons in stainless steel, compact enough for an apartment, office, RV or galley.
- No power, pump or plumbing. Keeps working through storms, outages and boil-water notices (boil or disinfect the water first if you're under a notice).
- No silver in the filter media, the issue behind the EPA stop-sale that left Black Berkey filters hard to find.
- Not sure what's in your water? Enter your ZIP code for our free Tap Water Check.
How It Works
- Fill the top chamber with cold tap water. No electricity, pressure or plumbing needed.
- Carbon stage. Gravity pulls the water slowly through two coconut-shell activated carbon filters, designed to reduce chlorine taste and odor.
- Fluoride stage. Water leaving each carbon filter passes straight into a Post-Treat filter threaded onto its stem, a second stage dedicated to fluoride.
- Pour and drink. Filtered water collects in the lower chamber, ready at the spigot. Keep the top chamber topped up and you always have a supply on hand.
Technical Specifications
| Capacity | 6 liters (1.6 gallons) |
| Best for | 1–2 people, apartments, offices and RVs |
| Construction | Stainless steel upper and lower chambers, lid and spigot |
| Filter stage 1 | Two coconut-shell activated carbon filters |
| Filter stage 2 | Two Post-Treat fluoride filters with stainless steel housings |
| Carbon filter life | Replace every 6–12 months, depending on your water and how much you use. Rated by the manufacturer for up to about 5,500 gallons per pair. |
| Post-Treat filter life | Replace every 3–4 months, depending on your water and how much you use. |
| Lab testing | Independent lab tests: lead, free chlorine, PFOA/PFOS and 58 VOCs reduced below detection limits; fluoride reduced 90% (see Independent Lab Results) |
| Power and plumbing | None required |
| Weight | About 6.5 lb (with spigot and both filters installed) |
| Warranty | 1 year |
Independent Lab Results
Two independent laboratories tested the carbon filter cartridge used in Denali Spring gravity systems with water deliberately spiked with each contaminant.
| PFOA and PFOS (PFAS) | Reduced to below 0.005 µg/L (5 parts per trillion) through 1,500 liters (about 400 gallons) of testing |
| Lead | Below detection limit |
| Arsenic, cadmium, chromium, nickel | Below detection limit |
| Free chlorine | Below detection limit |
| 58 volatile organic compounds, including all four trihalomethanes (chlorination byproducts) | Below detection limit |
| Fluoride | Reduced 90% |
Sources: CVR Labs, Chennai, India, September 2021 (report 21080072.01); Atom Testing Laboratory, Bangalore, India, December 2023 (report 2312042, NSF/ANSI 53 test methods). These are independent lab tests, not NSF certification. Results in your home will vary with your water, how much you filter and filter age. Email info@denalispring.com for copies of the reports.
What's in the Box
- 1 × 6L (1.6 Gallon) stainless steel gravity filter housing (upper chamber, lower chamber and lid)
- 1 × stainless steel spigot
- 2 × coconut-shell activated carbon filters
- 2 × Post-Treat fluoride filters (one per carbon filter)
Setup in About 10 Minutes
- Wash both chambers and the lid with warm water and mild dish soap, then rinse.
- Insert the two carbon filters through the holes in the base of the top chamber and hand-tighten the wing nuts underneath. Snug is enough, so don't force them.
- Thread one Post-Treat filter onto the stem under each carbon filter, again hand-tight.
- Attach the spigot to the lower chamber, stack the chambers and fill the top.
- Let the first one or two batches run through and discard them. A little carbon dust at first is normal.
Care & Maintenance
- Wash the chambers every few weeks with warm water and mild dish soap. Skip abrasive pads so the finish stays bright.
- Never use soap on the filters themselves, and keep them out of the dishwasher.
- Carbon filters: Replace every 6–12 months, depending on your water and how much you use. Rated by the manufacturer for up to about 5,500 gallons per pair.
- Post-Treat fluoride filters: Replace every 3–4 months, depending on your water and how much you use.
- Replace sooner if flow slows noticeably or you notice a change in taste or odor.
How It Compares
- vs. a filter pitcher: no plastic tank, and it filters 1.6–2.1 gallons per batch instead of refilling a small pitcher all day.
- vs. bottled water: no cases to haul, no bottle waste, and a fraction of the monthly cost.
- vs. an under-sink system: no installer, no drilling, and it moves with you. Unlike reverse osmosis, carbon keeps the naturally occurring minerals in your water.
Not sure what's in your tap water? Run our free Tap Water Check. Enter your ZIP code to see what has been reported in your local water system and which filter fits it.
Frequently Asked Questions
Does it remove the minerals from my water?
No. Activated carbon is not reverse osmosis, so naturally occurring minerals like calcium and magnesium stay in your water.
What do the Post-Treat filters do?
They add a second stage dedicated to fluoride. Each one threads onto the stem of a carbon filter, so water always passes through the carbon first.
How often do I change the filters?
Replace every 6–12 months, depending on your water and how much you use. Rated by the manufacturer for up to about 5,500 gallons per pair. Post-Treat filters: replace every 3–4 months, depending on your water and how much you use.
Is it tested?
Yes, by two independent labs. See the Independent Lab Results above, and email info@denalispring.com for copies of the reports.
Will it fit Berkey filters, or will your filters fit my Berkey?
Yes. Denali Spring carbon filters also fit Berkey and similar stainless gravity systems.
Can I use it for camping or hurricane season?
Yes. It needs no power, so it keeps working through outages. Start with treated or otherwise safe water. If you're under a boil-water notice, boil or disinfect the water too.
Do I need a stand?
No, but a stainless steel stand raises the system so a glass or small pitcher fits under the spigot more easily.
What warranty do I get?
Denali Spring products come with a 1-year warranty, and unused items in their original packaging can be returned within 30 days.
Important: Denali Spring gravity filters are made for municipally treated or otherwise microbiologically safe water. They are not designed to remove bacteria, viruses or cysts. If your water comes from an untreated source (a lake, stream or untested well) or you are under a boil-water notice, disinfect it before or after filtering.
Shipping, Returns & Warranty
- Free U.S. shipping on orders over $49.99
- Ships from Florida within 2 business days
- 30-day returns on unused items in original packaging
- 1-year warranty on Denali Spring products
Questions before you order? Email info@denalispring.com and a real person will answer.
